产品名称：	405有机担体填充色谱柱
产品型号：
品牌：	1941
产品数量：
产品单价：	面议
日期:	2023-06-14

405有机担体填充色谱柱的详细资料

405有机担体填充色谱柱
405有机担体填充色谱柱 详细信息：

05有机担体

名称	组成	颜色	堆密度/g·ml-1	比表面	性	使用温度/℃	主要分析用途
				/m2·g-1
405	二乙烯苯.三氯乙烯共聚物	--	--	<150	较强	--	--

Specification: 2m*3mm
Model: 405 organic carrier
Application: Determination of water, aldehydes, alcohols, ketones

规格：2m*3mm

型号：405有机担体

应用：水，醛，醇，酮的测定

405有机担体填充色谱柱 测试谱图：

Each column is rigorously tested
Full range of columns
Reliable technical support
Years of accumulated chromatographic analysis experience and technical team
Quality assurance:
High-quality stainless steel tubes, glass tubes and chromatographic packings for a variety of highly efficient packed columns
If you need to use stainless steel filter as the plug at both ends of the column, please specify when ordering.
If an on-column injection is used, there will be 6 CM of space at the front of the column inlet.
In order to prevent the elution of the chromatographic packing, both ends of the column are sealed with silanized glass wool.
If a valve injection or non-column injection column is used, the column inlet is filled
Glass column configuration for a wide range of gas chromatographs
2mm inner diameter glass column tube has a bevel at the entrance to facilitate injection
Each column is fully aging and rigorously evaluated
Precautions
Thank you for purchasing the column produced by Haohao.
Every column provided by Haohao is aging. To ensure the analytical separation you get, please aging for 1-2 hours before use. When aging, the carrier gas should be passed for about 10 minutes. After the air in the column is replaced, the temperature is raised to the high temperature of the Zui.
To avoid contamination of the detector, do not connect the column to the detector during aging.
When the oven temperature is higher than room temperature, a small amount of oxygen in the carrier gas will damage the stationary phase in the column. The carrier gas must be further deoxidized by a deoxidizing tube (it is recommended that the oxygen content of the carrier gas used should not exceed 1 ppm)
When installing the column, the product grade should be facing the operator.